Control Chief TM6000 Instrukcja Operatora Pobierz pdf (Strona 154)

TM 10-3930-660-10

0016 00-2

TRANSMISSION OIL SAMPLING VALVE SERVICE - CONTINUED 0016 00

TRANSMISSION OIL SAMPLING

1. Clean the transmission oil sampling valve (1).

2. Start the engine (WP 0005 00). Drive the vehicle approximately one mile or allow to idle in gear for a while to bring the

transmission to normal operating temperature.

3. With the engine running, place the travel select control lever in neutral. Apply the parking brake.

4. Obtain the oil sample.

a. Remove the dust cap (2) on the transmission oil sampling valve (1).

c. Place a clean container under the valve (1) opening

(or hose if used).

d. Push down or pull up on the lever (3) to drain

approximately one pint of oil prior to taking a sam-

ple. Release the lever (3) to close the valve (1).

e. Place a sample bottle under the valve opening (or

hose if used) and fill it to within 0.5 in. (12.7 mm)

from top. Cap the bottle immediately.

f. Install a dust cap (2) on the transmission oil sam-

pling valve (1).

g. Check transmission fluid level and add oil if neces-

sary.

END OF WORK PACKAGE

409-063

TRANSMISSION

PISTON PUMP

409-063

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 200 201

Brak uwag

Control Chief TM6000 Instrukcja Operatora Strona 154